![codemeter disk configuration codemeter disk configuration](http://helpcenterint.wpengine.netdna-cdn.com/wp-content/uploads/archicadwiki/codemeter-knownissues--codemeterdisksetup.png)
- #CODEMETER DISK CONFIGURATION SERIAL NUMBERS#
- #CODEMETER DISK CONFIGURATION SERIAL NUMBER#
- #CODEMETER DISK CONFIGURATION DRIVERS#
- #CODEMETER DISK CONFIGURATION LICENSE#
#CODEMETER DISK CONFIGURATION SERIAL NUMBER#
CmStick with Serial Number 3-4282892 and version 4.03Ĭonfiguration: LocalDisk with ActivePartition For a dongle that has been configured as a mass storage device the output looks like this: W:\>cmu32 -s 3-4282892 -show-config-disk You can output the current configuration of the dongle via cmu32 -s 3-4282892 -show-config-disk.
#CODEMETER DISK CONFIGURATION SERIAL NUMBERS#
Dongle serial numbers usually start with 3- (if yours starts with 2- or 1- the firmware of your dongle is too old to support HID mode), so in the above example the serial number would be 3-4282892. CmContainer with Serial Number 128-2308711 and version 1.19ĭetermine the serial number of your dongle. CmContainer with Serial Number 3-4282892 and version 4.03
#CODEMETER DISK CONFIGURATION LICENSE#
This should produce a list of the available CodeMeter license containers like this: W:\>cmu32 -listĬmu32 - CodeMeter Universal Support Tool. Plug in the dongle and open a command window (no administrative privileges required…). To switch a given dongle to human interface device (HID) mode, please to the following:
![codemeter disk configuration codemeter disk configuration](https://helpcenter.graphisoft.com/wp-content/uploads/ac22_help/020-configuration/MissingFavoriteContent-360x200.png)
To reconfigure the dongle as a human interface device, the cmu32.exe utility that is installed with (or, more precisely, with the CodeMeter runtime that is installed by ) will be required (usually located in %ProgramFiles%\CodeMeter\Runtime\bin%). Note that at least 12.01.000 (aka 2016) will be required for that. The only way around that - short of establishing an exception for the CodeMeter key - is to reconfigure the dongle as Human Interface Devices. One of the side effects of this is that if the OS is configured to block/ignore all USB-based mass storage devices, the CodeMeter dongle will not be detected.
#CODEMETER DISK CONFIGURATION DRIVERS#
In principle this is neat because it allows the devices to function without the installation of a system-level driver as the operating system already has the necessary drivers in place.